SmartBridges sB3412 - Manual (Page 22)

Page 22 of 78
i n t e l l i g e n t w i r e l e s s p l a t f o r m
airClient™ Nexus PRO TOTAL User Guide
2.7.2. Wireless Configuration
The wireless parameters need to be configured to allow the aCNPT in Bridge mode to associate with an
airPoint™ (sB3210) in Bridge mode.
Follow the steps below to configure the aCNPT Bridge Mode wireless association parameters:
1. Select ‘Main – aCNPT Bridge Mode’ from the ‘Radio’ drop-down menu on the menu bar.
2. Enter the SSID and access point’s radio MAC address.
3. Choose a radio regulatory domain and channel from the drop down lists.
4. Select the transmit power of the radio from the Dial-a-Power drop down menu and select the
appropriate gain of the antenna.
5. Enter the RF cable loss based on the cable specifications.
6. Click ‘Apply Changes’. The units will attempt to associate.
7. Click on the ‘View Association Table’ to check for the associated clients.
Figure 2-10 aCNPT Bridge Wireless Settings