Sanyo ECD-T1545 - Manual (Page 3)

SIRIUS MODE SELECTION .........….............…….…..(5)
Press LOC/S-MODE button (5) to switch Category mode, Skip mode or normal. It is used as the
selection of each:
Normal Category mode Direct Tune Skip Channel mode
When Category mode or Skip mode is engaged, the “CATEGORY” or “SKIP” function is turned
on in the display. When Category mode or Skip mode is released, the “CATEGORY” or “SKIP”
function is turned off. When Direct mode is engaged, “DIRECT” of alphanumeric display is turned
on.
Select Category and TUNE UP/DOWN within selected Category
Use CAT-DIR button (7) or CAT-DIR button (6) to select desire Category and press
BAND/LOU/ENT button (2).
In Category mode, stations can be tuned within the same category.
-
When the user wishes to search by Category, press LOC/S-MOD button (5) can be pressed
until it goes into Category search mode.
- Press CAT/DIR button (7) or CAT/DIR button (6) up and down to get to the desired
category.
- To change channels, press LOC/S-MODE button (5) again to Normal mode, and then press
MANU/SKIP/CH
or button (3) to select the channel up or down.
The operation of skip channel function
In Skip mode, pressing LOC/S-MODE button (5) for more than 3 seconds sets the SKIP channel
mode. Details for set or release skip channel as follows.
Use MANU/SKIP/CH
or button (3) to be switched SKIP channel set or release mode
sequentially.
- Press
BAND/LOU/ENT button (2) to select skip or release the following channel. (If the
channel was skipped, the “SKIP” icon will be displayed.
- Press LOC/S-MODE button (5) for more than 3 seconds again to return to basic mode
automatically after 10 seconds.
Note:
In skip mode, use MANU/SKIP/CH
or button (3) to show skipped channels.
How to direct tune
1. In direct mode, display shows DIRECT and “000” channel number. (Hundred Digit flashing
on/off)
2. Use MANU/SKIP/CH or button (3) to select hundred digit.
3. Press LOC/S-MOD button (5) again to confirm entry of the hundred digit and the 10s digit is
flashing on/off.
4. Use MANU/SKIP/CH or button (3) to select 10s digit.
5. Press LOC/S-MODE button (5) again to confirm entry of the 10s digit and the 1s digit is
flashing on/off.
6. Press LOC/S-MODE button (5) again to confirm entry of the 1s digit.
7. Press BAND/LOU/ENT button (2) to direct tune.
3