Sanyo ECD-T1545 - Manual (Page 9)

GENERAL OPERATION
VOLUME
OPEN
SEL
IR
EQ
DSP AS/PS MON MUT LOC MODE
MANU/SKIP/CH
BAND
LOU/ENT/ENT
A-Z/0-9
ECD-T1545
50W x 4
P.SCN
MP 3
1 PAU 3 RPT 2 SCN 4 SHF 6 DISC
S-MODE
CAT-DIR
5 DISC SW
2
1 5 10 9 4
8 3
7
6
TURNING THE POWER ON........................Any button
Install the front panel and press any button (except OPEN button) when ACC is on.
TURNING THE POWER OFF ...............................….. (1)
When system is on, press the button (1) to turn off the unit.
VOLUME LEVEL CONTROL.......................................(2)
Rotate the VOLUME dial (2) to adjust the volume level.
ADJUSTING THE SOUND
CHARACTERISTICS ..................................…..... .(2), (3)
Press the SEL button (3) shortly:
1. Each time you press the SEL button (3) shortly, the item changes as follows;
VOL BAS TRB BAL FAD
(Volume) (Bass) (Treble) (Balance) (Fader)
2. Rotate the VOLUME dial (2) to adjust the selected item. Make the adjustment within 5
seconds after selecting. After 5 seconds, the display window will revert to display priority.
Adjustment Range
BASS (BAS 00) BAS –10 BAS 10
TREBLE (TRB 00) TRB –10 TRB 10
BALANCE (BAL L=R)
10L 10R
FADER (FAD F=R) 10F 10R
Beep Sound Adjustment:
Press and hold the SEL button (3) for several seconds to enter beep sound adjustment mode,
then rotate the VOLUME dial (2) clockwise or counter-clockwise to select as follows:
BEEP 2ND BEEP ALL BEEP OFF
- BEEP 2ND mode:
The beep is only generated when all allowed double function button is pressed for several
seconds.
6