Samson GT100C - Manual (Page 10)

6
ENGLISH
6
Guided Tour - Rear Panel
A C
B
D E F
A. AC POWER INLET - Use the supplied grounded AC power cord to connect your GT Series
amplifier to mains power. This cord comes supplied with the appropriate plug for your
geographic area. CAUTION: Do not use an adapter to defeat the third grounding pin on this
plug or severe electric shock may result!
B. SPEAKER OUTPUTS – These jacks are used to connect the GT100 head to one or two exter-
nal Hartke GH412 cabinets.
C. VENT - The Vent provides vital cooling to your Model GT100. Make sure that it is kept free
of all obstructions and that cool, fresh air is accessible at all times. Also, try to ensure that
the Model GT100 is used in a dust-free environment.
D. FOOTSWITCH jack - Connect the included footswitch for CRUNCH on/off and Channel
selection.
E. EFFECTS RETURN - Use this 1/4 " unbalanced jack to return signal from a professional out-
board effects processor.*
F. EFFECTS SEND - Use this 1/4" unbalanced jack to send signal to a professional outboard
effects processor.* Output level is approximately -10 dB to +4 dB and is post-EQ and post-
Volume. The signal from this output can also be used as a Direct Out for recording.
* In-line effects (such as foot pedals) intended for low signal levels should be placed
between your guitar and the front panel GT SERIES amplifier Input and not connected with
the rear panel Effects Loop jacks.