Sanyo PLV-55WM1 - Manual (Page 13)

13
Part Names and Functions
To insure safe operation, please observe the following precautions :
● Use two AA, UM3 or LR06 type alkaline manganese batteries.
● Replace two batteries at the same time.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If a battery has leaked on the remote control, carefully wipe case clean and install new batteries.
● Risk of explosion if the battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions.
Pull up the lid
and remove it.
Remove the battery
compartment lid. Slide the batteries
into compartment. Replace the compartment lid.
Two AA size batteries
For correct polarity (+ and
–), be sure battery
terminals are in contact
with pins in compartment.
1 2 3
Pa
rt
Names and Functions
Remote Control Batteries Installation
Point the remote control toward the LCD Projection Monitor
(Infrared Remote Receiver) whenever pressing any button.
Maximum operating range for the remote control is about 16.4’
(5m) and 60° in front of the LCD Projection Monitor.
Remote Control Operating Range
60°
16.4’ (5 m)