Sanyo PLV-55WM1 - Manual (Page 15)

15
This LCD Projection Monitor uses nominal input voltages of 100-
120 V or 200-240 V AC. This LCD Projection Monitor automatically
selects the correct input voltage. It is designed to work with
single-phase power systems having a grounded neutral conductor.
To reduce the risk of an electrical shock, do not plug into any other
type of the power system.
Consult your authorized dealer or service station if you are not sure
of the type of power being supplied.
Connect the LCD Projection Monitor with all peripheral equipment
before turning the LCD Projection Monitor on. (See p16,17 for
connection.)
Connect the AC Power Cord (supplied) to the LCD
Projection Monitor. The AC outlet must be near this
equipment and must be easily accessible.
THE SOCKET-OUTLET SHOULD BE INSTALLED NEAR THE EQUIPMENT AND EASILY ACCESSIBLE.
CAUTION
For safety, unplug the AC power cord when the LCD Projection
Monitor is not in use.
When this LCD Projection Monitor is connected to the outlet
with the AC power cord, it is in stand-by mode and consumes a
little electric power.
Connecting the AC Power Cord
Preparation
NOTE ON THE POWER CORD
AC power cord must meet requirement of the country where you use a LCD Projection Monitor.
Confirm an AC plug type with the chart below and proper AC power cord must be used.
If supplied AC power cord does not match your AC outlet, contact your sales dealer.
To power cord connector
on your LCD Projection
Monitor.
LCD Projection Monitor side AC outlet side
Ground
To the AC outlet.
(120 V AC)
For Continental Europe For the U.S.A. and Canada For the U.K.
To the AC outlet.
(200 - 240 V AC)
To the AC outlet.
(200 - 240 V AC)
Pr
epar
ation