Syncing process – cont’d, Wait for 60 seconds – Star Trac SPINNING 727-0083 User Manual
Page 17
14
8. With the computer window still displaying “Conn” hold the magnet
about 1/2 inch (1.2 cm) away from the edge of the cadence sensor
with the large arrow pointing towards the magnet.
Wave the magnet back and forth several times until the window on
the computer displays a random ID number (e.g. ID 45896).
Finally, accept ID by pressing the Toggle (right) button.
10. Once the Syncing Process is done, the display should be in the Workout Mode.
Wait for 60 seconds.
You must wait for 60 seconds to allow the computer to reset the ID properly.
12. Test for response by turning the computer on then waving a magnet across the cadence
sensor, as you did in the test on page 10. By doing this you are simulating the same motion
as when the flywheel rotates and the magnet passes by the cadence sensor. If you see RPM
displayed, then the cadence sensor and computer were synced successfully. Proceed with
the installation and mounting to the bike.
NOTE: Remember to keep the computer and cadence sensor as a set at all times.
Syncing Process – cont’d