Star Trac SPINNING 727-0083 - Manual (Page 22)

19
Time required:
15 Minutes
Parts required:
727-0083 Spinning
®
Computer Kit
NOTE: The thick insert is used on the V-Bikes
Tools required:
M5 Allen Wrench
M2 Allen Wrench
Place the thick insert inside the bottom part of the
Mounting Bracket Clamp. Position the mounting
bracket onto the center-curved portion of the handlebars. Once positioned correctly, tighten
the 4 M6x20 screws using the M5 Allen tool.
Install the computer onto the mounting bracket by
sliding the computer clamp over the long portion of the
bracket. Tighten computer clamp with the M6 screw
and nut using the M5 Allen tool.
Note: Use the M6x30 screw for the computer
clamp when installing onto the computer
mounting bracket.
Mounting Computer On Handlebars - V-Bikes