Sony IPELA SNC-P1 - Manual (Page 57)

A
d
mini
s
tra
ting
t
he
Came
ra
Setting the Motion Detection Function — Motion detection setting Menu
57
Setting the Motion
Detection Function
—
Motion detection setting Menu
When you click Motion detection on the Advanced
mode menu, the Motion detection setting menu appears.
You can set the conditions to activate the built-in motion
detection function in this menu.
This is the same menu with the setting menu which is
displayed when you click Motion detection in Alarm
sending of e-Mail (SMTP) setting menu, Alarm sending
or FTP client setting menu, Alarm recording of Image
memory setting menu and so on.
Notes
• The motion detection function can activate or be set
only when the Video mode of the camera is set to
MPEG4 and the Cropping is set Off.
• Before actual use, perform an operation test and
confirm that the Motion detection function works
correctly.
Monitor display
You can monitor the moving image and set the detection
Window.
Window 1 to 4 check box
When you check it, the specified Window is displayed
on the monitor display.
Threshold slider bar
Set the Threshold level so as to judge whether there has
been any motion in the camera image or not. You can
change the Threshold level displayed in the Motion
detection indicator.
Motion detection indicator
The moving level of the present shooting image inside
the specified Window is shown in the graph. The even
line shows the threshold level for Motion detection
which will be a guide to set the sensitivity properly.
Sensitivity slider bar
Use it to set the detection sensitivity of the monitoring
image.
When the slider bar is moved to the left end, the
sensitivity will be 0 and any motion will not be detected.
The right end is the maximum sensitivity.
OK button
Click to send the set values to the camera and confirm
the settings.
Setting the Motion Detection Area,
Sensitivity and Threshold level
Set the motion detection working area, the sensitivity
and the threshold level as follows:
1
Check Window 1 check box.
Window 1 is shown on the monitor display.
2
Settle Window 1 in the area you want to set Motion
detection.
Click and drag Window 1 to move it or change the
size of it.
3
Set the Sensitivity of Motion detection.
Adjust it referring to the level indicator of Motion
detection.
To increase the sensitivity, move the Sensitivity
slider bar to the right.
To decrease, move it to the left.
When you release the mouse, the new setting is
applied to the level of motion detection indicator.
4
Set the Threshold level of Motion detection.
Adjust the Threshold slider bar in the same way of
step 3 to set the level the camera executes motion
detection.
5
If necessary, set the Motion detection working
areas, the sensitivities and the Threshold level of
the other Windows 2, 3, 4 by following steps 1 to 4.
6
After all settings, click OK.