Sony IPELA SNC-P1 - Manual (Page 60)

A
d
mini
s
tra
ting
t
he
Came
ra
Using DDNS Service — DDNS Setting Menu
60
3
On the router’s setup menus, check the global IP
address (for example, xyz.37.128.50 in the above
diagram) on the WAN side currently assigned by
the provider. Type the global IP address in the PC
browser and check if you can access the camera.
Notes
• To specify a port number other than 80 for port
forwarding, type a colon (:) after the global IP
address and then type the port number. (For
example: http://xyz.37.128.50:1024)
• On some routers, you cannot access the WAN
side global IP address via a network on the LAN
side of the router. In this case, check it using
another Internet access.
• After the above setup, the camera can be accessed
from any computer connected to the Internet. If
you want to restrict access to the camera, perform
the user setting and security setting procedures in
the camera setting menus.
• If you cannot access the camera after performing
the above setup, consider the following
possibilities.
A
The IP address that the provider assigns may
not be a global IP address.
B The port number (for example, Port 80) set for
port forwarding may be blocked by the
Internet Service Provider.
t Check with the provider.
C The port number set for port forwarding may
be blocked by security software or a firewall
installed in the computer.
t Check the settings of the security software
or firewall.
4
Click DDNS of the Administrator setting menu to
display the DDNS setting menu.
The followings are explanations for the setting
menu item.
[DDNS]
Select whether to use the dynamic DNS function or
not by on or off.
Even after you have registered for the dynamic
DNS service, set it to off when you are not using it.
[DDNS ID]
This is the ID special for the equipment which is
used for the dynamic DNS service. It is used when
you proceed with New registration, Modify/
Unregister, Forgot password and so on in the
registration site.
When you access the registration site through the
DDNS setting menu page, the DDNS ID will have
already been input.
[Password]
[Re-type password]
Type the password set for dynamic DNS access. It
must consist of 6 to 16 characters, including letters
of the alphabet and numerals.
[New registration]
It is used when you proceed with New registration
for the dynamic DNS service. For details, refer to
the instructions below.
[Modify registration/Unregister]
This is used to jump to the Modify/Unregister page
of the registration site. For details, refer to “Modify
Registration/Unregister Process” given in the
registration site (http://www.register-snccam.net).
[Forgot password]
This is used to jump to the Forgot password page of
the registration site.
[Refresh IP address]
This is used when you proceed with manual
updating of the IP address for the DDNS server.
The camera routinely proceeds with updating of the
IP address at about hourly intervals, so you do not
need to use this button.
When you have pressed the reset button or
proceeded with Factory default after registration for
dynamic DNS, you can restart the dynamic DNS
service by this button.