Programmable counter array (pca0), Figure 22.1. pca block diagram, Section “22. programmable counter array – Silicon Laboratories C8051F347 User Manual

Page 255

Advertising
background image

Rev. 1.3

255

C8051F340/1/2/3/4/5/6/7/8/9/A/B/C/D

22. Programmable Counter Array (PCA0)

The Programmable Counter Array (PCA0) provides enhanced timer functionality while requiring less CPU
intervention than the standard 8051 counter/timers. The PCA consists of a dedicated 16-bit counter/timer
and five 16-bit capture/compare modules. Each capture/compare module has its own associated I/O line
(CEXn) which is routed through the Crossbar to Port I/O when enabled (See

Section “15.1. Priority

Crossbar Decoder” on page 144

for details on configuring the Crossbar). The counter/timer is driven by

a programmable timebase that can select between six sources: system clock, system clock divided by four,
system clock divided by twelve, the external oscillator clock source divided by 8, Timer 0 overflow, or an
external clock signal on the ECI input pin. Each capture/compare module may be configured to operate
independently in one of six modes: Edge-Triggered Capture, Software Timer, High-Speed Output, Fre-
quency Output, 8-Bit PWM, or 16-Bit PWM (each mode is described in

Section “22.2. Capture/Compare

Modules” on page 257

). The external oscillator clock option is ideal for real-time clock (RTC) functionality,

allowing the PCA to be clocked by a precision external oscillator while the internal oscillator drives the sys-
tem clock. The PCA is configured and controlled through the system controller's Special Function Regis-
ters. The PCA block diagram is shown in Figure 22.1

Important Note:

The PCA Module 4 may be used as a watchdog timer (WDT), and is enabled in this mode

following a system reset. Access to certain PCA registers is restricted while WDT mode is enabled. See

Section 22.3

for details.

Figure 22.1. PCA Block Diagram

Capture/Compare

Module 1

Capture/Compare

Module 0

Capture/Compare

Module 2

Capture/Compare

Module 3

Capture/Compare

Module 4 / WDT

CEX1

EC

I

Crossbar

CEX2

CEX3

CEX4

CEX0

Port I/O

16-Bit Counter/Timer

PCA

CLOCK

MUX

SYSCLK/12

SYSCLK/4

Timer 0 Overflow

ECI

SYSCLK

External Clock/8

Advertising
This manual is related to the following products: