Special instructions, Save these instructions – Sunbeam 3932 User Manual
Page 3
l
Your
Iron is designed to rest on the heel rest.
Do
not leave the iron unattended.
Do
not set the iron
on an unprotected surface, even if it is on its heel rest.
SPECIAL INSTRUCTIONS
l
This is a 400 watt appliance.. To avoid a circuit
overload, do not operate another high wattage
appliance on the same circuit.
l
If an extension cord is absolutely necessary,
a lo-ampere cord should be used. Cords rated
for less amperage may overheat. Care should
be taken to arrange the cord so that it cannot
be pulled or tripped over.
l
This appliance was set at the factory to operate at
120 Volts. Refer to Operating Instructions Section
of this manual for conversion to 240 Volt operation.
l
Be sure dual voltage selector is in the correct voltage
position before operation. Before plugging iron into
outlet, read the information about dual voltage
operation in the “Voltage” section of this manual.
l
To reduce the risk of electrical shock, this appliance
has a polarized plug (one
blade is wider than the
other). This plug fits a polarized outlet only one way;
if the plug does not fit fully into the outlet, reverse
the plug. If it still does not fit, contact a qualified
electrician.
Do
not attempt to defeat this safety feature.
SAVE THESE
INSTRUCTIONS
3