Sunbeam 3932 User Manual
Page 6
Lift the fill hole cap on the water tank and
fill with clean tap water (See Figure 5).
Replace the fill hole cap, ensuring th
it is fastened securely.
Snap the front of the water tank
into the iron base (See Figure 6).
Slide the water tank release button
backwards and hold into position with
F
IGURE
5
one hand. Press back of water tank into
position with other hand and release the
button to lock the tank in place.
IRONING
Plug iron into an electrical outlet.
Use the “Fabric Setting” chart to
determine the best setting and method
for the fabric you plan to iron.
F
IGURE
6
Move the fabric select dial to the desired setting.
The temperature can be adjusted by turning the dial clockwise
until the indicator mark is aligned with the proper setting.
Allow the iron to heat for approximately five minutes.
While the iron is heating, make sure it is sitting on its
heel rest and handle on a stable, protected surface.
For particularly stubborn creases, the
S
HOT OF
S
TEAM
@
function can be used if the temperature adjustment dial
is on the hottest setting.
Set the fabric select dial to the “cotton/linen” setting.
Wait for the iron to reach temperature, press the steam button
firmly and release.