Sony UP20 - Manual (Page 15)

Pre
par
at
ion
Before Printing
15
2
Remove the protection sheet placed on the top of
the paper.
3
Close the cover of the paper tray, and then slide the
paper tray back into the printer until it clicks into
place.
Note
When you cannot slide the paper tray back into the
printer, check whether or not paper or printouts are
left around the paper outlet slot. Remove them if
there are.
When storing the paper
• Avoid storing the paper in a location subject to:
– high temperatures
– high humidity
– excessive dust
– direct sunlight
• Use the original package for storing unused paper.
Selecting the Input Signal
Before printing, select the appropriate input signal (the
input connector to which the signal to be printed is being
input) VIDEO, S VIDEO, or RGB.
1
Turn on the video monitor and the printer.
2
Press the MENU button and display the INPUT
SETUP menu by pressing the
F, f, G or g button.
3
Select INPUT SEL by pressing the F or f button.
Riffle the paper with
the protection sheet.
Place the paper
along with the
protection sheet
in the paper tray
with the printing
surface facing
up.
Front
Set the paper securely
under the tab.
Partition
1
2, 5
2, 4, 5
2, 3
Switch IN to green by pressing the F , f , G or g button,
then the INPUT SETUP menu appears.
Position the cursor at INPUT SEL by
pressing the
F or f button.