Sony UP20 - Manual (Page 21)

O
per
at
ion
Making Full-Size Image Printouts
21
2
Press the PRINT QTY button until the desired
number appears, while the screen which appears in
step 1 is displayed.
Repeatedly pressing the PRINT QTY button
increases the number up to a maximum of 9. Or
repeatedly pressing the
g button also increases the
number up to a maximum of 9.
To decrease the number of copies
While the screen which appears in step 1 is displayed,
press the
G button. Each time you press the G button, the
number decreases and stops at 1.
Setting the printout quantity using the menu
1
Display the PRINTER SETUP menu according to
the operations of step 1 described in “Making
Printouts with the Desired User Set Number” on
page 19.
2
Select PRINT QTY by pressing the F or f button.
3
Select the desired number of copies by pressing the
G or g button.
4
Press the MENU button.
The regular screen appears.
Note
Do not leave more than 10 sheets of printouts on the
paper tray. Doing so may cause a paper jam. Even if
fewer than 10 sheets of printouts have been accumulated
on the paper tray, the printer may stop printing for
various reasons and the message “REMOVE PRINTS”
appears. In such a case, remove printouts accumulated
on the paper tray. The printer will start to print
remaining copies automatically.
If the paper runs out during printing
The printer stops the printing operation.
Load the paper into the paper tray and press the PRINT
button.
However, the printout quantity is reset to the original
quantity requested before printing was stopped.
For example, if the printout quantity is set to 5, and the
paper runs out when three copies are printed, the
printout quantity is reset to 5. If you want to print only
the remaining copies, set the printout quantity to 2 after
loading the paper. (See “Loading Paper” on page 14.)
Press the PRINT QTY button or g button until the
desired number appears.
Position the cursor at PRINT QTY by pressing the
F or f button.
When you want to Button
Increase the quantity. g
Decrease the quantity. G
Display the desired number of copies by
pressing the
G or g button.