Samsung SADT-100HM - Manual (Page 4)

SADT-100HM_ 3
ENG
5. As in the <Figure 1> below, pull out the external cables in connection with the camera through the
pipe into which the Hanging Mount Adaptor is installed.
Refer to <Figure 2> and wrap the screw part of the Pipe with the Teflon Tape. In the next step, insert
the Cables through the center of the Hanging Mount Adator and pull them out to the opposite side.
Fix the Hanging Mount Adaptor to the end of the processed Pipe with a 1.5"NPT screw thread by
turning it clockwise, as described in the <Figure 3>.
6. Prepare the Camera Adaptor for the applicable camera.
Refer to the installation guide for the applicable camera and configure the initial settings of the Camera
Adaptor.
(For more information about the initial settings, see the installation guide for the Camera)
In the next step, fasten the connector of the external cable (see step 4 above) with the Connectors of
the Camera Adaptor. In addition, connect the Camera Adaptor of the BNC Jack of the external cable
to the BNC Jack of the Camera Adaptor.
For more information about the cable connection, see the installation guide for the Camera.
PIPE
1.5” NPT
CONNECTOR BNC JACK
PIPE
1.5” NPT
TEFLON TAPE
HANGING
MOUNT
ADAPTOR
< Figure 1 > < Figure 2 >
PIPE
HANGING
MOUNT
ADAPTOR
< Figure 3 >
HANGING
MOUNT
ADAPTOR
CAMERA ADAPTOR
EXTERNAL CABLE
CONNECTOR
CAMERA ADAPTOR
BNC JACK
SADT-100HM_ENG.indd 3 2008-01-23 오후 4:35:33