Sony STR-DA3100ES - Manual (Page 60)

masterpage:Left
lename[E:\SEM_Janet\DATA_DA3100ES\J9041615_2514877111STRDA3100ESU\251487711
\GB08REM_STR-DA3100ES-U.fm]
60 US
model name1[STR-DA3100ES]
[2-514-877-11(1)]
Set the remote command mode using the RM
SET UP button and Easy scroll key (PUSH).
Use a suitable tool to press the RM SET UP
button.
Selecting the command mode
You can switch the command mode (AV1 and
AV2) of the remote. If the command mode of the
receiver and the remote is different, you cannot
use the remote to operate the receiver. The initial
setting is AV2. To change the command mode
of the receiver, see page 74.
1
Hold down RM SET UP and press ?/1.
2
Move the Easy scroll key (PUSH) to
select “MAIN”.
3
Press PUSH.
4
Move the Easy scroll key (PUSH) to
select “AV1” or “AV2”.
5
Press PUSH.
The indicator lights up once (twice for
AV2), then the command mode switches.
You will be able to see your selection (AV1
or AV2) in the display.
To reset the remote to factory
settings
Press ?/1, AV ?/1 and MASTER VOL – at
the same time.
The indicator flashes 3 times, then goes off.
You can program the remote to control non-
Sony components by changing the code. Once
the control signals have been memorized, you
can use those components as part of your
system.
Furthermore, you can also program the remote
for Sony components that the remote is unable to
control. Note that the remote can only control
components that accept infrared wireless control
signals.
1
Hold down RM SET UP and press
AV ?/1.
The indicator lights up and “IR SET”
appears in the display.
2
Move the Easy scroll key (PUSH) to
select the input (including TV ?/1) for
the component you want to control.
For example, if you are going to control a
CD player, select SA-CD.
3
Press PUSH.
4
Press the numeric buttons to enter the
numeric code (or one of the codes if
more than one code exists)
corresponding to the component and
the maker of the component you want
to control.
See the tables on pages 61–63 for
information on the numeric code(s)
corresponding to the component and the
maker of the component (the first digit and
the last two digits of the numeric code
correspond to the category and the maker’s
code respectively.)
5
Press ENTER.
Once the numeric code has been verified,
the indicator slowly flashes twice and the
remote automatically exits the
programming mode.
6
Repeat steps 1 to 5 to control other
components.
Selecting the command
mode of the remote Programming the remote
GB01COV_STR-DA3100ES-U.book Page 60 Wednesday, January 19, 2005 5:30 PM