Sony STR-DA3100ES - Manual (Page 68)

masterpage:Left
lename[E:\SEM_Janet\DATA_DA3100ES\J9041615_2514877111STRDA3100ESU\251487711
\GB09REM_STR-DA3100ES-U.fm]
68 US
model name1[STR-DA3100ES]
[2-514-877-11(1)]
Notes
• Some functions explained in this section may not
work depending on the model.
• The above explanation is intended to serve as an
example only. Therefore, depending on the
component the above operation may not be possible
or may operate differently than described.
You can change the factory settings of the input
buttons to suit the components in your system.
For example, if you connect a LD player to the
VIDEO 2 jacks on the receiver, you can set the
VIDEO 2 button on this remote to control the
LD player.
Note, however, that the settings of the TUNER
button cannot be changed.
1
Press RM SET UP for more than 2
seconds.
The indicator lights up.
2
Press the input button you want to
change the assignment of.
The indicator turns off once and turns on
again when a valid button is pressed. Only
the first input button that is pressed will be
registered.
Example: Press VIDEO 2.
3
Refering to the table below, press the
input button for the category you want.
The indicator turns off when a valid button
is pressed.
Example: Press DVD twice.
4
Press SOURCE.
The new assignment is registered.
The indicator slowly lights up twice, then
goes off.
To cancel
Press RM SET UP during any step.
Tips
• If the operation is unsuccessful, the indicator flashes
four times and the remote automatically exits the
button assignment mode. In this case, the new
assignment is not registered and the previous setting
remains.
• Use a suitable tool to press RM SET UP button.
Changing button
assignments
GB01COV_STR-DA3100ES-U.book Page 68 Wednesday, January 19, 2005 5:30 PM