Symphonic ZEKTOR MAS3 - Manual (Page 12)

12
Setting Power On Defaults
The MAS3 power on default mode
When toggling between Standby mode and PowerOn the MAS3 will remember all it’s current set-
tings. After completely powering down the MAS3 (by unplugging the AC wall adapter), upon restor-
ing power (by plugging the AC wall adapter back in), it will power up in a user settable default mode.
This is useful in situations where the MAS3 is externally switched by a power strip.
The factory default settings for initial power on are:
• Initial power up in Standby mode.
• Input 1 selected when powered on.
• Auto-dimming mode selected.
Changing the MAS3 power on defaults
Teaching the MAS3 new power on default settings consists of placing the MAS3 in the preferred
initial power on mode, and pressing and releasing the SETUP button on the back panel of the
MAS3.
S TEP 1
1 Select an initial power on input.
Using the S
ELECT I N 1
- S
ELECT I N 3
keys, or the S
ELECT +
or S
ELECT -
keys, choose the desired power on default input.
S TEP 2
2 Select the initial Bright / Dim / Auto-dimming mode.
Using the S
ET D IM M ODE
key, choose the desired power on default
Bright / Dim / Auto-dimming mode.
S TEP 3
3 Select the initial power mode, Standby or Powered on.
Using the P
OWER T OGGLE
, P
OWER ON or P
OWER OFF keys, choose
the initial power on mode.
S TEP 4
4 Press and release the SETUP button located on the back panel of
the MAS3. The power Indicator light on the MAS3 will blink once to
indicate the new power on setting have been saved.
or
The previous picture shows the default power up mode, as being
set to the standby mode. It may also be set to the power on mode,
by pressing and releasing the setup key while power is on, as
shown here.
3 2 1 ZEKTOR
3 2 1 ZEKTOR
3 2 1 ZEKTOR
3 2 1 ZEKTOR
3 2 1 ZEKTOR