SOYO 6KB82440 - Manual (Page 16)

12 Hardware Setup
Slot 1 Installation Guide
This mainboard provides a non-boxed 686 (PII) CPU retention set to
secure the CPU on this board. Follow the steps below to secure this type
of CPU on to your motherboard.
Step 1:
Find the ATX PW and the Slot 1 on the board and set the board in the
direction as follows before doing any installation.
ATX PW
Slot 1 (for Pentium II CPU)
Install the 2 pairs of screws, as shown in the following figure, from the
bottom of the motherboard upward onto the mainboard.