SOYO 6KB82440 - Manual (Page 36)

32 BIOS Setup
IDE HDD Block Mode Choose Enabled (default) or Disabled.
Enabled invokes multi-sector transfer
instead of one sector per transfer. Not all
HDDs support this function.
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Secondary Master
PIO
IDE Secondary Slave
PIO Choose Auto (default) or mode 0~4.
Mode 0 is the slowest speed, and HDD
mode 4 is the fastest speed. For better
performance and stability, we suggest you
use the Auto setting to set the HDD
control timing.
On-chip Primary/
Secondary PCI IDE Enabled: Use the on-board IDE (default)
Disabled: Turn off the on-board IDE
PCI Slot IDE 2nd
Channel Choose Enabled (default) or Disabled.
When Enabled is set, IRQ15 is dedicated
for secondary IDE use. When Disabled is
set, IRQ15 is released for other devices.
Onboard FDC Controller Enabled: Use the on-board floppy
controller (default).
Disabled: Turn off the on-board floppy
controller.
Onboard Serial Port 1
Onboard Serial Port 2
Choose serial port 1 & 2Õs I/O address.
Do no set port 1 & 2 to the same value
except for Disabled.
COM 1/3F8H | COM3/3E8H
COM 2/2F8H | COM4/2E8H
(default) |
UART 2 Mode Standard: Use standard UART mode
(default).
ASK IR: Use UART with ASK. IR
function enable.
HPSIR: Use UART with HP.. Serial IR
function enable.