SOYO 6KB82440 - Manual (Page 34)

30 BIOS Setup
IRQX and
DMAX assigned
to Choose PCI/ISA PnP or Legacy ISA. If the first
item is set to Manual, you could choose IRQX
and DMAX assigned to PCI/ISA PnP card or ISA
card.
PCI/ISA PnP: BIOS auto assigns IRQ/DMA to
the device.
Legacy ISA: User assigns IRQ/DMA to the
device.
PCI IRQ
Activated By Choose Edge or Level. Most PCI trigger signals
are Level. This setting must match the PCI card.
PCI IDE IRQ
Map To Select PCI-AUTO, ISA, or assign a PCI SLOT
number (depending on which slot the PCI IDE is
inserted). The default setting is PCI-AUTO. If
PCI-AUTO does not work, then assign an
individual PCI SLOT number.
Primary IDE
INT# Choose INTA#, INTB#, INTC#, or INTD#. The
default setting is INTA#.
Secondary IDE
INT# Choose INTA#, INTB#, INTC#, or INTD#. The
default setting is INTB#.
3. After you have finished with the PCI Slot Configuration, press the
<ESC> key and follow the screen instructions to save or disregard
your settings.
Load Setup Defaults
This item loads the system values you have previously saved. Choose
this item and the following message appears:
ÒLoad SETUP Defaults (Y/N)? NÓ
To use the SETUP defaults, change the prompt to ÒYÓ and press
<Enter>.
Note: The SETUP Defaults are optimized for the most stabilized
performance.