SoundCraft UREI 1601E - Manual (Page 25)

25
RETURN / AUX -LEVEL
This control sets the amount of signal coming back from the connected effects unit. At the fully anti-clockwise position there will be
no sound. As the control is moved in a clockwise direction the input level will be gradually increased until, at the fully clockwise
position, the input level will be at its maximum.
CLIP INDICATOR
The [CLIP] indicator is used to detect overload conditions in the gain section before the A/D convertor. When a good signal level is
detected, the indicator will not light. When the level becomes too high for the A/D convertor, the indicator will illuminate and the audio
sound will become distorted. If this occurs, back-off the [LEVEL] control until the [CLIP] indicator is not illuminated.
RETURN -SELECT
This control selects the point at which the returning effects are re-introduced. There are three “patch” points to choose from, as
detailed below:
1. CHANNEL 1 -The return signal will be routed directly to the CH1 bus (pre-channel volume fader).
2. MASTER -The return signal will be routed directly to the Master bus (pre-master volume fader).
3. CHANNEL 2 -The return signal will be routed directly to the CH2 bus (pre-channel volume fader).
NOTE: When SEND [SELECT] is set to [MASTER], all three return settings will automatically be set to MASTER to
prevent feedback loops occurring.
NOTE: the [FX] switch must be turned ON to input the signal.
FX ON/OFF SWITCH
The performance “paddle” type FX switch controls the ON/OFF status of the external effects. You can use the spring-loaded momentary
ON position to flick-in effects “on-the-fly” or use the locked-ON position for more sustained periods of externally processed sound.
When the [FX] switch is in the centre “OFF” position there will be no return from the connected effects device.
When the [FX] switch is in the forward LOCK-ON position, the sound, as set by the RETURN [SELECT] control, will be returned from
the connected effects device. The indicator stays on in this mode to show that FX return is activated. When the [FX] switch is pulled
and held back to the “ON” position the sound, as set by the RETURN [SELECT] control, will be returned from the connected effects
device. The indicator stays on in this mode to show that the FX return is activated. When the switch is released, it will automatically
return to the centre “OFF” position.
FX SEND/RETURN RE-CONFIGURATION
If you want to use the return as a 4th line level input, the configuration must be changed each time power is switched on.
With power turned OFF, pull and hold back the [FX] paddle switch (momentary ON position). Turn the power ON at the
mains plug and then after a few seconds release the [FX] paddle switch. The return input is now constantly active whilst
the [FX] paddle switch controls the send signal.
NOTE: This special configuration setting is lost when power is turned off. If you want to use the return as a 4th line level
input, always remember to hold the [FX] switch to ON before turning on the power.