SoundCraft UREI 1601E - Manual (Page 46)

46
PRE-SET VOICE LIST
Multi programs
X-Encoder Y-Encoder Isolator “on”
Bank B
1 Filter Frequency 50% Filter Resonance Low-Mid-Hi
2 Cutter Mix 50% Delay Speed Low-Mid-Hi
3 Cutter Mix 50% Filter Frequency Low-Mid-Hi
4 Cutter Mix 50% Filter Env Mod Low-Mid-Hi
5 Cutter Mix 50% Filter Frequency Low Hi
Bank C
1 Delay repeats 75% Filter mix Low Hi
2 Cutter mix 100% Flanger freq (set res @ 75%) Mid-Hi
3 Flanger Freq 50% Flanger depth Low Hi
4 Delay Mix 25% Flanger resonance Low Hi
5 Cutter Mix 100% DelaySpeed/Filt mix Low-Mid-Hi
Bank D
1 Delay repeats 100% Filter Resonance Mid-Hi
2 Cutter Mix 75% Delay input drive Low-Mid-Hi
3 Filter Env Mod 50% Filter Frequency Low Hi
4 Delay Mix 25% Filter Frequency Low-Mid-Hi
5 Cutter Mix 50% Delay speed Mid-Hi
Bank E
1 Cutter depth 25% Filter Resonance Mid-Hi
2 Delay repeats 75% Filter Frequency Low Hi
3 Cutter Mix 50% Filter frequency Low-Mid-Hi
4 Cutter Mix 25% Filter env mod Low-Mid
5 Cutter Mix 75% Filter env mod Low-Mid-Hi
Bank F
1 Delay speed 100% Delay repeats Low Hi
2 Delay speed 50% Delay repeats Low-Mid-Hi
3 Delay speed 75% Flanger freq Low-Mid-Hi
4 Filter freq 75% Delay speed Low-Mid-Hi
5 Filter env mod 100% Delay speed Low Hi
All Y parameter values set to 50% default.
HINTS & TIPS
Synchronisation and Tempo Changes:
Always make slow changes when adjusting the sound source pitch control. This will allow the effects to remain in synchronisation
during tempo changes.
Never make tempo changes during quite passages (when beat information is unavailable) as 1601E BPM engine will lose the BPM
range.