Sprint Nextel SP7084 - Manual (Page 31)

31 TAD Operation
2. Select ANSW .
3. Select NEXT twice until GREETING
SETUP appears.
4. Select ENTER . RECORD GRT appears.
5. Select NEXT three times until CHECK
GREETING appears.
6. Select ENTER . PLAY GREETING 1
appears.
7. Repeatedly select NEXT until the greet-
ing number you want to check appears.
8. Select START .
9. Press PROGRAM to exit.
SETTING THE GREETING
MODE
The system has two greeting modes. Answer
asks the caller to leave a message. An-
nounce Only is simply an announcement and
does not let the caller leave a message. The
system is preset to Answer.
Note: Announce Only lets you set the sys-
tem to route the call to a specified station
and leave a message on that station.
1. Press PROGRAM .
2. Select ANSW , then select NEXT twice
until GREETING SETUP appears.
3. Select ENTER , then select NEXT twice
so GRT MODESELECT appears.
4. Select ENTER . MODE ANSWER
appears.
5. Select CHANGE to toggle between
ANSWER and ANNC ONLY .
Note: If a greeting has not been
recorded,
PLEASE RECORD GREET-
ING 1 appears.
6. Select DONE .
7. Press PROGRAM to exit.
SELECTING THE PRIMARY
GREETING
After recording all the greetings, select the
primary greeting. The factory preset greeting
is Greeting 1.
Note: When the greeting timer is pro-
grammed (see “Setting the TAD to Answer
Calls” on Page 32), you cannot select a pri-
mary greeting. The greeting that plays during
the programmed time is always Greeting 1.
Greeting 2 plays the rest of the time.
1. Press PROGRAM .
2. Select ANSW .
3. Select NEXT twice until GREETING
SETUP appears.
4. Select ENTER .
5. Select NEXT . SELECT GRT appears.
Select ENTER .
If the greeting timer is turned on, CAN-
NOT SELECT GREETING – GREET-
ING TIMER IS ON scrolls across the
display.
GRT n NO RECORD appears if the
selected greeting has not been
recorded.
6. Select CHANGE to choose the main
greeting you want to answer calls. GRT
n RECORDED appears. Select DONE .
7. Press PROGRAM to exit.
43-5708.fm Page 31 Monday, September 18, 2000 7:56 AM