Sprint Nextel SP7084 - Manual (Page 38)

38 Troubleshooting
PERFORMING A SYSTEM
UPDATE
The system update renews the status of all
the stations in the system. The system auto-
matically updates itself when you discon-
nected Line 1, reconnected it or when AC
power has failed and then been restored.
You must manually update the system when
you remove a station from the system or
change an extension ID.
If the network is set to full capacity and a sys-
tem update is required,
PERFORM SYSTEM
UPDATE AT A DIFFERENT STATION or
UPDATE NEEDED appears. The station
showing either display is not properly linked
to the system, so perform the system update
at another station.
1. Press PROGRAM .
2. Select OTHER .
3. Repeatedly select NEXT until SYSTEM
UPDATE appears.
4. Select YES . UPDATING NOW appears.
When the update completes, FIN-
ISHED appears.
5. Press PROGRAM to exit.
RESETTING THE TIME AND
DATE
The backup batteries keep the clock running
for about one hour after a power failure. If the
power is out for more than one hour, you
must reset the clock.
1. Press PROGRAM , then select ANSW .
2. Select NEXT . TIME&DAY SETUP
appears. Select ENTER . The time set-
ting menu appears.
3. Use the keypad to enter the hour and
minutes in two digits. Precede a single-
digit hour or minute with 0 (01, 02, 03,
and so on).
If you make a mistake, select BACK to
reenter the correct time.
4. Select SAVE , then NEXT . The AM/PM
selection menu appears.
5. Select CHANGE to toggle between AM
and PM . After setting AM or PM correctly,
select NEXT . The date setting menu
appears.
6. Use the keypad to enter the month (01–
12) and day (01–31).
If you made a mistake, select BACK to
re-enter the correct date.
7. Select SAVE , then NEXT . Day of the
week setting menu appears.
8. Select CHANGE until the correct day of
the week appears. Then select NEXT .
9. Press PROGRAM to exit.
Note: INPUT CORRECT DATA appears if
you enter an invalid date or time. Check and
correctly enter the data.
43-5708.fm Page 38 Monday, September 18, 2000 7:56 AM