SpectraLink NetLink e340 - Manual (Page 39)

SpectraLink Corporation Configuration and Administration—NetLink e340/i640 Wireless Telephone
Cisco CallManager and IP Phone 7960 Emulation
72-1082-02-F.doc Page 39
8. Testing a Handset
Verify proper registration and operation of each handset by performing the
following tests on each handset in an active wireless area.
1. Power on the handset by pressing
Power On . You will see a series of messages
displayed as the handset acquires the system. The handset should display the user
extension or dashes if no extension is programmed. Any error messages should
clear.
2. Press the Start Call key. The extension number should be replaced by
information from the CallManager and you should hear dial tone. Place a call and
listen to the audio quality. End the call by pressing the End Call key.
3. Place a call to the handset and verify ring, answer, clear transmit, and clear
receive audio.
4. Go off-hook and use the FCN key to verify the Features list.
5. Go off-hook and use the LINE key to verify the Line appearances / Line features
list.
6. Press the End Call key. Any line indicators should turn off and the extension
number display will return.