Sony DAV-IS50 - Manual (Page 81)

Ad
v
a
nc
ed Settings and Adjus
tments
81 US
Note
• Depending on the DVD, [4:3 LETTER BOX] may be
selected automatically instead of [4:3 PAN SCAN] or
vice versa.
x [PROGRESSIVE (COMPONENT OUT)]
You can set the progressive signal that is output
from the COMPONENT VIDEO OUT jacks to
on/off. For details, see “Does your TV accept
progressive signals?” (page 28).
1
Select [ON], then press .
The confirmation display appears.
2
Press C/c to select [START].
The system outputs the progressive signal
for 5 seconds. Check that the screen is
displayed correctly.
3
Press C/c to select [YES].
The system outputs the progressive signal.
If you select [NO], the system will not
output the progressive signal.
Note
• [PROGRESSIVE (COMPONENT OUT)] is
effective only when you connect the control unit and
TV with a component video cord (page 20).
x [4:3 OUTPUT]
When you use a 16:9 aspect ratio TV, you can
adjust the aspect ratio to watch 4:3 aspect ratio
signals. If you can change the aspect ratio on
your TV, change the setting on your TV, not the
system.
Note
• [4:3 OUTPUT] is effective only when you set [TV
TYPE] in [VIDEO SETUP] to [16:9].
x [BLACK LEVEL]
You can select the black level (setup level) for
the video signals output from the jacks other
than COMPONENT VIDEO OUT/HDMI OUT.
x [BLACK LEVEL (COMPONENT OUT)]
You can select the black level (setup level) for
the video signals output from the
COMPONENT VIDEO OUT jacks.
You cannot select this and the setting is not
effective when the system outputs progressive
signal.
x [PAUSE MODE] (DVD VIDEO/DVD-R/
DVD-RW only)
You can select the picture in pause mode.
[ON] The system outputs interlace
signals.
[OFF] The system outputs progressive
signals. When you select [ON],
follow the steps below.
[FULL] Select this when you can change
the aspect ratio on your TV.
[NORMAL] Select this when you cannot
change the aspect ratio on your
TV. A 16:9 aspect ratio signal
with black bands on left and right
sides of the image appears.
[ON] The standard level.
[OFF] You can lower the standard black
level. Use this when the picture
becomes too white.
[OFF]
You can set the black level of the
output signal to the standard level.
[ON] You can raise the standard black
level. Use this when the picture
becomes too black.
[AUTO] The picture, including subjects
that move dynamically, is output
with no jitter.
[FRAME] The picture, including subjects
that do not move dynamically, is
output in high resolution.
16:9 aspect ratio TV