SDI Technologies IHOME IP42 - Manual (Page 9)

7
Listening to Aux device
Using the aux line-in Jack
You can play any iPod or other MP3 player or portable audio device through the iP42 via the aux line-in Jack.
1. Plug one end of a standard stereo audio patch cord (not included) into the headphone or line-out jack on your device and
the other end of the patch cord into the iP42 aux line-in Jack located on the back of the unit.
2. Press the Radio Button until “aux” appears in the lower part of the display.
3. Turn on and play your device.
4. Turn the Volume Wheel to adjust the iP42 volume. You may need to adjust volume on your audio device, too.
5. Press the EQ Button to select and turn the Set Wheel to set Treble, Bass, and Left/Right Balance.
6. To turn off the unit, press the Button. Please remember to turn off your device, too.
Sleep mode, Dimmer and more
Sleep Operation
Sleep mode lets you sleep to your iPhone/Pod or radio, gradually lowering the volume until the unit shuts off at the selected
time.
1. Press the Sleep Button to enter sleep mode. The sleep time will show in the lower display.
2. Press the Sleep Button again as needed to adjust the sleep timer from 120, 90, 60, 30 or 15 minutes.
3. When the display changes back to show the real time, press the Sleep Button once to show the sleep time remaining.
Pressing it again will change sleep time to next lowest increment.
4. iP42 has independent volume setting for sleep mode so you can adjust the sleeping volume without affecting the normal
volume. The sleep volume will remain at that level the next time you enter sleep mode until controls are changed.
5. To stop listening at any time, press the Button to turn unit off.
Dimmer Operation
During normal operation, press the Snooze/Dimmer Button to control the brightness of the LCD display.
Using the iP42 in Other Countries
Different regions of the world use different FM radio frequency steps and ranges. You will need to select the one that matches
the standards in your region (USA, EUROPE, JAPAN, AUSTRALIA,or CHINA). The default setting is USA; if you live in the US,
you may skip this section.
1. Make sure the iP42 is OFF (not playing in any mode). Press and hold the Radio Button for about 5 seconds until “USA”
appears in the lower part of display. Tune the Set Wheel to adjust country frequency to your region.
2. Press the Radio Button again (or no button within 5 seconds) to exit the radio frequency setting mode.
Updated Mar 2