Sharp TINSE4377FCZZ - Manual (Page 52)

50
SELECTING A SPECIAL MODE
The procedure for selecting settings for "Adding margins (Margin Shift)" is
explained below as an example. Although the specific settings for each
special mode vary, the general procedure is the same.
1 Place the originals.
When using the document glass,
place the original with the side to be
scanned face down.
2 Select settings in the touch
panel.
(1) Touch the [Special Modes]
key.
(2) Touch the [Margin Shift]
key.
Settings to shift the margin 3/4"
down will be selected.
(3) Select 3/4" for the front
side and 3/4" for the
reverse side using the
keys.
The margin shift position is initially
set to "Up".
To set the margin shift position to
"Right", "Left", or "Down", touch
the corresponding key.
(4) Touch the [OK] key.
The side to be scanned must be face up!
Copy Ratio
100%
Original Paper Select
Auto
8½x11
Plain
Exposure
Auto
Special Modes OK
3/4
Margin Shift
Right
Down
Up
Left Side 1
(0~1)
inch
3/4
Side 2
(0~1)
inch
OK Cancel
Special Modes
2-Sided Copy
Output
File
Quick File
Special Modes
1
2
Quick File
Image Edit
2in1
OK
File
Stamp
Erase
Job
Build
Sharpness
Card Shot
Margin Shift Pamphlet Copy
Transparency
Inserts
Plain
1. 8½x11
2. 5½x8½
3. 8½x14
4. 8½x11
8½x11
(4)
(2)
(1)
(3)
mxb401_us_qck.book 50 ページ ２００９年１月８日 木曜日 午後２時１分