Samsung SIR-S4120R - Manual (Page 23)

4-8 4-7
DIGITAL VIDEO RECORDER
3
Record Setup
The following illustrates the intial setting of the RECORD MODE SETUP menu.
① DVR INPUT
Set the 3 types of Video Input signals going into the DVR.VIDEO-IN is the input signal
going into the BNC Video Jack, S-VIDEO is the signal going into the S-VHS Jack, and
VCR PB is the VCR playback signal. [VIDEO-IN/S-VIDEO / VCR PB]
② AUDIO RECORD
Set to ON to record video and audio at the same time, or set to OFF to record video only.
Audio is input and recorded at 6.3 Kbps regardless of the recording field rate of the video
[ON/OFF].
➂ PICTURE QUALITY
Picture quality is divided into four levels. Set to VERY HIGH for the best picture quality,
or set to HIGH, NORMAL, or LOW in the descending order of qualty. The user can select
the desired quality. [VERY HIGH/HIGH/NORMAL/LOW]
➃ PICTURE RATE
Set the picture rate for the input video. Up to 60 FPS (Fields Per Second) can be recorded.
(SCR-3000P models can record up to 50 FPS (Fields Per Second)
● SCR-3000N/SSC-Dual (NTSC)
[60.00FPS/30.00FPS/15.00FPS/10.00FPS/7.50FPS/5.00FPS/2.50FPS/1.00FPS/
0.50FPS]
● SCR-3000P (PAL)
[50.00FPS/25.00FPS/12.50FPS/8.33FPS/6.25FPS/5.00FPS/2.50FPS/1.00FPS/
0.50FPS]
RECORD MODE SETUP
DVR INPUT VIDEO-IN
AUDIO RECORD ON
PICTURE QUALITY HIGH
PICTURE RATE 30.00FPS
DISK END MODE OVERWRITE
DISK END BUZZER ON
RECORD TIME MARK ON
TIME MARK POSITION RIGHT
MOVE=[ / ❷ / ➛ / ❿ ] SELECT=[ ] EXIT=[MENU]
➄ DISK END MODE
● If you select STOP, recording will stop when you consume the full HDD space.
● Setting this to OVERWRITE will continue to record the current data by overwriting the
previous data. The relative positions where the recorded data are being stored in the HDD
will be indicated on the screen in a bar format. If the DISK END MODE is set to STOP,
in addition, the remaining HDD capacity will be indicated in percentage (%).
[OVERWRITE/STOP]
➅ DISK END BUZZER
If set to ON, the Buzzer will sound when the HDD is full during the recording; if set to
OFF, the Buzzer will not sound. DISK END MODE needs to be set to STOP for activation.
[ON/OFF]
➆ RECORD TIME MARK
If set to ON, the recording time will be displayed during playback; if set to OFF, it will not
be displayed. [ON/OFF]
⑧ TIME MARK POSITION
Set the location on the screen where the time of recording will be displayed during
playback. Set to LEFT to display it on the bottom left of the screen, or set to RIGHT to
display it on the bottom right of the screen. [LEFT/RIGHT]
Note Note
Set DVR input to VCR PB mode to show video in live video on screen. You can record
the videotape into hard disk drive while playing it. Note that OSD will not display while
recording. This is normal.
Please note that you cannot open VCR menu while setting the DVR input to VCR PB
mode. Timer record setting in DVR menu is disabled as well.