Sharp XL-HP505 - Manual (Page 15)

15
XL-HP505
Ba
sic Ope
ration
Setting the clock
In this example, the clock is set for the 12-hour (AM 12:00) display.
To confirm the time display:
Note:
The "CLOCK" or time will flash to confirm the time display when the
AC power supply is restored after a power failure or unplugging the
unit. If incorrect, readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from step 1. If the time display is flash-
ing, step 4 (for selecting the 12-hour or 24-hour display) will be
skipped.
To change the 12-hour or 24-hour display:
Note:
The clock can also be set with the remote control.
1 Press the ON/STAND-BY button to turn the power on.
2 Press the CLOCK/TIMER button.
3 Within 10 seconds, press the or button to select
"CLOCK", and press the MEMORY/SET button.
4 Press the or button to select 12-hour or 24-hour dis-
play and then press the MEMORY/SET button.
"AM 12:00" The 12-hour display will appear.
(AM 12:00 - PM 11:59)
"AM 0:00" The 12-hour display will appear.
(AM 0:00 - PM 11:59)
"0:00" The 24-hour display will appear.
(0:00 - 23:59)
5 Press the or button to adjust the hour and then press
the MEMORY/SET button.
Press the or button once to advance the time by 1 hour.
Hold it down to advance continuously.
6 Press the or button to adjust the minutes and then
press the MEMORY/SET button.
Press the or button once to advance the time by 1
minute. Hold it down to change the time in 5-minute intervals.
1 Press the CLOCK/TIMER button.
2 Within 10 seconds, press the or button until the current
time is displayed.
The time display will appear for about 10 seconds.
1 Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 33 for details.]
2 Perform "Setting the clock" from step 1.