Sharp FO-1470 - Manual (Page 135)

Messages and Signals
133
11. T
roub
le
-
s
hooti
n
g
Messages and Signals
Display messages
Note: If you have turned on the Caller ID function, see Caller ID in
Chapter 8 for display messages related to Caller ID.
CHECK PAPER SIZE The paper size setting is incorrect. Change the paper
size setting as explained on page 20.
COVER OPEN The print compartment cover. Close it.
DOCUMENT JAMMED The original document is jammed. See the following
section, Clearing Paper Jams.
FAX RX IN MEMORY A fax has been received in memory because the
imaging film needs replacement, you have run out of
printing paper, or the paper is jammed. After you fix
the problem, press the START key to print out the fax.
FILM END The imaging film may need replacement. Check the
film and replace if necessary.
FUNCTION MODE The FUNCTION key has been pressed.
HOLD The HOLD/SEARCH key has been pressed to put the
other party on hold during a phone conversation.
Press the HOLD/SEARCH key again to take the
other party off hold, or simpley lift the handset if was
placed on the cradle after initially pressing the HOLD/
SEARCH key.
LCR DOWNLOADING The fax machine has called OpenLCR and is
receiving carrier rate data. This message only
appears if you have registered with OpenLCR.
DOWNLOAD ERROR The fax machine was unable to download rate data
from OpenLCR. Try downloading the data manually
as explained in Downloading (receiving) the rate data
manually on page 35.
all-ux510A.book Page 133 Thursday, September 14, 2000 9:05 AM