Sharp FO-1470 - Manual (Page 40)

Setting Up and Using OpenLCR
38
The following table shows marks related to OpenLCR that may
appear in the display.
Mark Meaning
OpenLCR has been activated and is ready for use.
(Blinking)
OpenLCR cannot be used because the rate data has
been erased. Your fax will automatically call
OpenLCR within the next 24 hours to receive new
data, or you can download the data manually if you
need to use OpenLCR immediately. See
Downloading (receiving) the rate data manually on
page 35.
The rate data in the fax is no longer correct and the
fax cannot connect to OpenLCR to obtain new data.
See What to do if “E” appears in the display on page
41.
OpenLCR has been temporarily turned off. See
Temporarily turning off OpenLCR below.
Rate data was not yet available when your fax called
OpenLCR. Your fax will automatically call OpenLCR
again when the rate data is available. Until that time,
long distance calls will be routed through your
primary carrier.
(Blinking)
Your fax will automatically call OpenLCR within the
next 24 hours to learn when correct rate data will be
available.
Your fax did not receive rate data because OpenLCR
was unable to identify it by Caller ID. To remove the
“H” display, press the OpenLCR key followed by #, 1,
8, 4, and #. To receive OpenLCR service, you will
need to contact your phone company and allow it to
send your Caller ID information when you place calls.
After this, register once again with OpenLCR.
all-ux510A.book Page 38 Thursday, September 14, 2000 9:05 AM