Samsung Digimax A7 - Manual (Page 122)

❾➓ 102 ❾➔
Starting PC mode
➃❃ If you connect the USB cable to a USB port on your PC and then turn on the power,
the camera will automatically switch to "computer connection mode".
➃❃ In this mode, you can download stored images to your PC through the USB cable.
➃❃ The LCD monitor is always turned off in PC mode.
➃❃ The camera status lamp will blink when the files are transferring via the USB connection.
❾✃ Connecting the camera to a PC
1. Turn the PC power on.
2. Turn the camera power on.
3. In any mode other than Voice Recording mode, press
the MENU button.
4. Press the LEFT/ RIGHT button and select the [SETUP]
menu tab.
5. Select the [USB] menu by pressing the UP/ DOWN
button and press the RIGHT button.
6. Use the UP and DOWN buttons to select [COMPUTER], and then press the OK button.
7. Press the menu button twice and the menu will disappear.
8. Connect the PC and the camera via the USB cable.
- Insert the small plug of the USB cable into the camera USB connection terminal.
- Insert the large connector of the USB cable into the USB port of the PC.
- The plugs must be firmly inserted.
❾✃ Disconnecting the camera and PC : Refer to page 107(Removing the removable disk).
❾➪ If you selected [PRINTER] in Step 6,
when you connect the camera to your
printer, the [CONNECTING…]
message will be displayed on the LCD
monitor and the connection will not be
established. In this case, disconnect
the USB cable, and then follow the
procedure from Step 3 and onward.
❾➴ The camera driver must be installed before using PC mode.
❾➴ To save battery power, it is recommended that you use an AC adapter (Optional) when
connecting the camera to a computer.
INFORMATION
SETUP
LAMP
SOUND
USB
BACK: SET:OK
COMPUTER
PRINTER
3072