Sony CDX-C910RDS - Manual (Page 26)

26
Actual total number: Sony CDX-C910RDS ( E ,F,G) 3-856-717-11(2)
EN
5
Press (SOUND) for two seconds.
The display goes back to the normal
playback mode.
Listening to each
programme source in its
registered surround menu
— Last Sound Memory (LSM)
You can listen to the same source always in the
same surround menu even after changing the
programme source or turning the unit on and
off again.
Changing the line output
level
You can change the line output level if you
hear distortion or other noise.
1
Press (SHIFT), then press (2) (SET UP)
until “L.out” appears.
2
Press (4) (n) to select the desired
setting (–10 dB or –16 dB).
3
Press (SHIFT).
Additional
Information
Precautions
• If your car was parked in direct sunlight
resulting in a considerable rise in
temperature inside the car, allow the unit to
cool off before operating it.
• If no power is being supplied to the unit,
check the connections first. If everything is in
order, check the fuse.
• If no sound comes from the speakers of
two-speaker systems, set the fader control to
the centre position.
•If your car is equipped with a power aerial,
note that it will extend automatically while
the tuner function is selected.
If you have any questions or problems
concerning your unit that are not covered in
this manual, please consult your nearest Sony
dealer.
Notes on handling CDs
A dirty or defective disc may cause sound
dropouts while playing. To enjoy optimum
sound, handle the disc as follows.
Handle the disc by its edge. To keep the disc
clean, do not touch the surface.
Do not stick paper or tape on the labeled
surface.