Step 5: check the installation, Step 6: check steamer operation, Step 7: shut-down and wipe-clean steamer – Southbend STRE-5EZ User Manual

Page 17

Advertising
background image

S

TRATO

S

TEAM

EZ

C

OUNTERTOP

S

TEAMER

I

NSTALLATION

O

WNER

S

M

ANUAL

1189953

(10/08) P

AGE

17

OF

56

S

TEP

5:

C

HECK THE

I

NSTALLATION

Check the installation of each steamer, as follows:

1. Check that all screws and bolts are tightened.

2. Check that the electrical connection has been made correctly.

3. Check that the steamer is level. If not, adjust the legs (or level the countertop surface).

4. Check that the appropriate minimum clearances are satisfied (see page 4).

5. Check the door for proper alignment, and that it opens and closes properly.

6. Check that there is sufficient clearance in front of the steamer to open the door and to pull out the pans.

7. Wipe clean all surfaces.

S

TEP

6:

C

HECK

S

TEAMER

O

PERATION

Check the operation of each steamer, as follows:

1. Fill tank with water.

2. Set the Cook-Idle switch to COOK MODE.

3. Turn on the electric power supply.

4. Move the ON/OFF lever to the ON position and check that the Power light comes on.

5. Check that the timer and buzzer operate correctly.

6. Open the door and check that water is entering the cavity (NOTE: The fill rate is slow).

7. Wait four minutes, then check that some water has covered the bottom of the cavity.

8. Depress the door-switch actuator rod and listen for an audible “click.” Release the door-switch actuator rod

and listen for another audible “click.” (The clicks indicate that the contactor is functioning properly.)

9. Check that steam is escaping from the vent at the top left rear corner of the steamer.

10. Move the ON/OFF lever to the OFF position and check that the Power light goes out. Also check that the water

is draining correctly into the drain, and that the steamer completely drains.

S

TEP

7:

S

HUT

-D

OWN AND

W

IPE

-C

LEAN

S

TEAMER

Complete the installation by leaving the steamer ready for customer use:

1. Allow the steamer to cool.

2. Wipe clean all surfaces.

3. Unless the steamer is to be placed in service immediately, turn off the electric power supply.

4. Make sure that a copy of this manual will be available to the people who will operate and maintain the

steamer.

Advertising