Sony 76c - Manual (Page 33)

Projecting 33
4. Turn on your computer or video source if you have not already.
5. Press the P Power button on top of the projector to turn it on.
(You can also press the P Power button on the remote control.)
The projector beeps and the power light flashes green as the
projector warms up. The projector lamp comes on in about 4
seconds and the power light stays green.
■ If you’re using a computer, you should see your computer
display projected after a moment or two. If not, you need to
select the image source. See page 34.
(Windows only: If you see a message saying that it has found
a plug-and-play monitor, click
Cancel .)
■ If you’re projecting a video, press the Source Search button
on the projector or remote control to switch to your video
source. Then press the
Play button on your DVD player or
other device.
■ If you are prompted to enter a password, see page 67.
To focus and adjust the image, see page 37. If a projected image fails
to appear, see “What To Do If You See a Blank Screen” on page 34.
When you’re done with your presentation, shut down the projector as
described on page 41.
note
If you are using the remote
control for the first time, be
sure to insert the batteries as
described on the Quick
Setup poster.
Projector Remote control
Power button
warning
Never look into the lens when
the lamp is on. This can
damage your eyes, and is
especially dangerous for
children.