Scanport Ricoh SP 1200SF - Manual (Page 8)

6
19 To reduce the risk of fire, electric shock and injury
to people, note the following:
 DO NOT use this product near appliances that
use water, a swimming pool or in a wet
basement.
 DO NOT use the machine during an electrical
storm (there is the remote possibility of an
electrical shock) or to report a gas leak in the
vicinity of the leak.
 Do not dispose of batteries in a fire. They may
explode. Check with local codes for possible
special disposal instructions.
20 Caution - To reduce the risk of fire, use only No.26
AWG or larger telecommunication line cord.
Regulations
IEC 60825-1:2007 Specification
This machine is a Class 1 laser product as defined in
IEC 60825-1:2007 specifications. The label shown
below is attached in countries where required.
This machine has a Class 3B Laser Diode which
emits invisible laser radiation in the Scanner Unit. The
Scanner Unit should not be opened under any
circumstances.
Laser Diode
Wave length: 780 - 800 nm
Output: 10 mW max.
Laser Class: Class 3B
Warning
Use of controls, adjustments or performance of
procedures other than those specified in this
manual may result in hazardous radiation
exposure.
Disconnect device
This product must be installed near an AC power
outletelectrical socket that is easily accessible. In
case of emergencies, you must disconnect the power
cord from the AC power outletelectrical socket to shut
off power completely.
Wiring information (U.K. only)
If you need to replace the plug fuse, fit a fuse that is
approved by ASTA to BS1362 with the same rating as
the original fuse.
Always replace the fuse cover. Never use a plug that
does not have a cover. If in any doubt, call a qualified
electrician.
Warning - This printer must be earthed.
The wires in the mains lead are coloured in line with
the following code:
 Green and Yellow: Earth
 Blue: Neutral
 Brown: Live
Radio interference
This product complies with EN55022 (CISPR
Publication 22)/Class B. When connecting the
machine to a computer, ensure that you use the
following interface cables.
A USB cable which must not exceed 2.0 metres in
length.
CLASS 1 LASER PRODUCT
LASER KLASSE 1 PRODUKT