Sony RM-AV2500 - Manual (Page 37)

37
Transferring Data
between Remote
Commanders
You can transfer data, such as learned
signals and component code settings,
between this Commander and another
Sony RM-AV2500.
Transferring data
You can transfer the all data of this
Commander or the data of a Component
Select button on this Commander to
another Sony RM-AV2500.
To transfer the all data of the
Commander
3
4
6
2
Notes on learning the signals
of an air-conditioner
About seasonal adjustments
If you change the settings of the air-
conditioner for the season, you have to
program the remote control signals of the
new settings on the Commander.
If the power-on/off operation
does not work correctly
The air-conditioner may not be turned on
or off properly with the button of this
Commander, for which you have
programmed its power-on/off signal.
If the Commander can operate only
“ON” with one button and “OFF” with
another, while your air-conditioner’s
remote control can operate “ON/OFF”
with a single button, program the signal
on two buttons of the Commander as
follows.
1 Clear the learned power-on/off signal.
(In the example on page 36, clear the
learned signal from the SYSTEM
CONTROL B button.)
2 Program the signal (transmitted from
the power-on/off button of the air-
conditioner’s remote control) for the
SYSTEM CONTROL B button again.
3 Program the signal from the same
button of the remote control for
another button (for example, the
SYSTEM CONTROL C button).
The two buttons of the Commander have
been programmed with the power-on
signal and the power-off signal of the air-
conditioner, respectively so that you can
operate the air-conditioner with the
Commander.
Continued