Samsung SIR-T165 - Manual (Page 13)

Connecting Antennas
This section shows how to connect a cable TV with or without a cable box, and how to
connect an indoor or outdoor antenna.
1
Cable TV without a Cable Box: If you
have a cable TV and do not use a cable box,
connect the cable to RF (CABLE) INPUT on the
rear of the Set-Top Box.
2 Cable TV with a Cable Box: If you have
a cable box, connect as shown in the
illustration to the right.
If you want to connect a VCR with your cable
box, see the section on how to connect a
VCR with a cable box in page 1.7 .
3
Indoor/Outdoor Antenna: You may
need a 75Ω adaptor or a combiner, as
shown in the illustration right.
NOTES
• If your antenna has separate leads for VHF/UHF signals, you will need to purchase a
combiner and connect it as shown in illustration above.
• The Set-Top Box can receive DTV signals in the event that a local cable provider is passing
8VSB through on their system.
1.3
CHAPTER ONE
Connecting The Set Top Box
1 1
Ô DTV OUT (RGB format)
You can connect RGB to a TV, computer monitor, or another
video component input. 1080i, 720p, and 480p are available by set-
ting the RESOLUTION SELECT switch.
 DTV OUT COMPONENT (YP
B
P
R
format)
You can connect YP
B
P
R
to a TV, computer monitor, or another video
component input. As with DTV OUT (RGB format), 1080i, 720p, and
480p are available by setting the RESOLUTION SELECT switch.
Ò RS232C
Used for service.
Ú DVI OUT
Use to connect a device equipped with DVI interface.
DVI OUT supports HDCP function.(See Notes on page 1.9.)
Æ FireWire(IEEE1394) INPUT/OUTPUT
Use to connect external devices (D-VHS, AV-HDD, etc.)
ı L/R ANALOG-AUDIO OUTPUTS
Connect these terminals to the analog audio inputs of a TV set (i.e.,
to a TV that has jacks for L/R inputs). Or, connect these terminals to
the L/R inputs of a separate audio component.
MD68-00278A(E)-CHAPTER 1 3/8/03 1:07 PM Page 3