Samsung Digimax U-CA 3 - Manual (Page 22)

22
Starting recording mode
Recording a still image
Steps from 1-4 are the same as those for recording a movie
clip.
5. Select the STILL IMAGE( ) mode by sliding the mode
switch.
6. Point the camera towards the subject and compose the
image by using either the viewfinder or LCD monitor.
7. Press the shutter button to capture an image.
A [DELETE?] message may be displayed after taking a
picture. Refer to p.49 for more information about this
[DEL. ANSWER].
Recording Voice
Steps from 1-4 are the same as those for recording a movie
clip.
5. Select the VOICE RECORDING( ) mode by sliding
the mode switch.
6. Press the shutter button to record a voice.
- Press the shutter button once and voice is recorded for as
long as the available recording time(Max : 1 hour) allows.
The recording time will be displayed on the LCD monitor.
- Voice will still be recorded if the shutter button is released.
- If you wish to stop recording, press the shutter button again.
- File type : *.wav
A distance of 40cm between you and the camera (microphone) is the best distance to
record sound.
INFORMATION
Manner mode: Pressing the power button for more than 3 seconds changes the buzzer
and start-up sound setting to OFF, even though you may have set these to ON.
To turn on the startup sound and operation sound, set the startup sound (MyCAM
mode) and operation sound (Setup mode) to a submenu other than [OFF].
INFORMATION
[ STILL IMAGE mode ]
[ VOICE RECORDING mode ]
STANDBY
START.SHUTTER