Samsung Digimax U-CA 3 - Manual (Page 88)

88
Before contacting a service center
Please check the following
Symptom Causes Remedy
- Insert fresh batteries
- Connect an AC Power Adapter
- Insert the batteries according to the
polarity marks (+, -).
- There is low battery capacity
- An AC Power Adapter is not
connected
- Batteries are inserted
incorrectly with the reverse
polarities.
- The batteries are exhausted
- The Camera is turned off
automatically.
- The Adapter plug is not
connected securely
- The Camera is being used
in low temperatures
- The memory card is not
inserted
- There is insufficient memory capacity
- The memory card has not been formatted
- The memory card is
exhausted
- The camera’s power is off
- The batteries are exhausted
- The memory card is locked
- Batteries are inserted
incorrectly with the reverse
polarities.
The camera doesn t
switch on
The camera power
ceases whilst in use
Batteries drain
quickly
Camera does not
take images when
pressing the
Shutter button
- Insert fresh batteries
- Slide the power switch to reactivate
camera
- Remove and re-insert the plug
- Keep the camera in warm conditions
(i.e. inside a coat or jacket) and only
remove it in order to take images
- After turning the camera off, insert a new
memory card
- Delete unnecessary image files
- Format the memory card (p.66)
- Insert a new memory card
- Turn the camera power on
- Insert fresh batteries
- Slide the write protect switch to the
bottom of the memory card
- Insert the batteries according to the
polarity marks (+, -).
- The camera was stopped
due to a malfunction.
The camera
suddenly stops
working while in
use.
- Press the power button for longer than 3
seconds. The camera will restart to its
normal operation state.