Sub-Zero e Series - Manual (Page 10)

W O L F E S E R I E S B U I LT- I N OV E N S
E S E R I E S B U I LT- I N D O U B L E OV E N S
M O D E L S I C B D O 3 0 - 2 F / S A N D
I C B D O 3 0 - 2 U / S
IMPORTANT NOTE: A minimum 610 mm of
usable cabinet depth is required, or the back
panel of the cabinet may need to be removed
for proper installation. A minimum 635 mm of
usable cabinet depth is required for a flush
inset installation. The electrical box must be
flush with the back panel of the cabinet.
For ease of installation, Wolf recommends
using 838 mm wide cabinets with the E Series
double oven. A minimum 838 mm wide
cabinet is required for a flush inset installation.
The cabinet base platform must be able to
support 181 kg.
Refer to the following illustrations for overall
dimensions, installation specifications and
electrical location for the E Series double oven.
The E Series double oven requires a separate,
grounded 3-wire 220-240 V AC, 50/60 Hz, 50
amp service with its own circuit breaker. Refer
to Electrical Requirements on page 16. The
oven is not supplied with an electrical plug.
603 mm
BEHIND FRAME
1280 mm 1257 mm
718 mm
759 mm
603 mm
OPEN OVEN DOOR
TOP VIEW
67 mm
559 mm
32 mm 25 mm
48 mm
48 mm
RIGHT SIDE VIEW
759 mm
CONDUIT
CHANNEL
O V E R A L L D I M E N S I O N S – M O D E L S I C B D O 3 0 - 2 F / S A N D I C B D O 3 0 - 2 U / S
IMPORTANT NOTE: Unless you are using
cabinets deeper than 610 mm for a standard
installation or 635 mm for a flush inset installa-
tion, it is recommended that the electrical
supply be placed in an adjacent cabinet.
Choose the location shown in the installation
illustrations on pages 12–13 that best suits
your installation.
Unframed Model ICBDO30-2U/S shown.
10