Sub-Zero e Series - Manual (Page 20)

C O N T A C T
I N F O R M A T I O N
Website:
wolfappliance.com
T R O U B L E S H O O T I N G
IMPORTANT NOTE: If the built-in oven does
not operate properly, follow these trouble-
shooting steps:
Verify that power is being supplied to the
oven.
Check the electrical connections to ensure
that the installation has been completed
correctly.
Follow troubleshooting procedures as
described in the Wolf E Series Built-In
Ovens Use & Care Information.
If the oven still does not work, contact a
Wolf authorized service center. Do not
attempt to repair the oven yourself. Wolf
is not responsible for service required to
correct a faulty installation.
W I R I N G D I A G R A M
The wiring diagram covering the control circuit
is located on the top of the oven in a sealed
plastic bag.
W O L F E S E R I E S B U I LT- I N OV E N S
I F Y O U N E E D S E RV I C E
For service in your area, contact either your
Wolf dealer or visit the Showroom Locator
section of our website, wolfappliance.com
to find the regional distributor by country.
When calling for service, you will need the
built-in oven model and serial numbers.
Both numbers are listed on the product
rating plate, located on the right side of the
oven trim, directly above the door. Open
the oven door to view the rating plate.
Refer to the illustration on page 5 for
location of the rating plate.
20