Star Tech Development TSP100 - Manual (Page 41)

– 38 –
11. DIP Switch Settings
There are DIP switches located on the bottom of the PU model printers and various settings can
be performed as shown in the following table.
When changing the settings, use the following procedure.
Note: For U model printers, the DIP switch settings do not need to be performed.
(1) Turn the printer off and disconnect the power cable plug from the AC outlet.
(2) Remove the screw, and then remove the DIP switch cover on the bottom of the printer.
When the printer is shipped, DIP switch 1-4 is set to OFF;
all of the other switches are set to ON.
[PU model]
! "
DIP switch 1
OFF
ON
(3) Use a tool with a narrow tip to change the DIP switch settings.
(4) Install the DIP switch cover and secure it with the screw.
Note: The new settings will take effect after the printer is turned on.
DIP switch 1
Switch 1-1 Power consumption mode
OFF Standard mode
ON Low-power consumption mode (Default setting)
Always set DIP switches 1-2 and 1-3 to ON and DIP switch 1-4 to OFF.