Sharp DT-300 - Manual (Page 22)

Connections and Setup
-21
Connecting to a Computer
Optional
accessory
DVI to 15-pin D-sub adaptor
Type: AN-A1DV (7.9" (20 cm))
Connecting to a Computer
Using the DVI to 15-pin
D-sub Adaptor and the
RGB Cable (INPUT 2)
1
Connect a DVI to 15-pin D-sub
adaptor to the projector.
2
Connect the above adaptor to
an RGB cable.
3
Connect the above cable to the
computer.
• Secure the connectors by tightening the
thumbscrews.
Note
• Refer to “Computer Compatibility Chart” on
page 66 for a list of computer signals
compatible with the projector. Use with
computer signals other than those listed may
cause some of the functions not to work.
• When connecting the projector to a com-
puter in this way, select “RGB” for “Signal
Type” on the OSD menu or press
on
the remote control. (See page 52.)
• A Macintosh adaptor may be required for
use with some Macintosh computers.
Contact your nearest Sharp Authorized
Service Center or Dealer.
• Depending on the computer you are us-
ing, an image may not be projected unless
the signal output setting of the computer is
switched to the external output. Refer to
the computer operation manual for switch-
ing the computer signal output settings.
To INPUT 2 terminal
Notebook computer
To RGB output terminal
RGB cable
(commercially available)
DVI to 15-pin D-sub adaptor
(sold separately)
Connecting the thumbscrew cables
■ Connect the thumbscrew cable making sure that it fits cor-
rectly into the terminal. Then, firmly secure the connec-
tors by tightening the screws on both sides of the plug.
■ Do not remove the ferrite core attached to the RGB cable.
Ferrite core
03.10.29, 2:40 PM Page 21