Sharp DT-300 - Manual (Page 55)

-54 -54
Using the “Options” Menu
Selecting the Menu
Screen Position
This function allows you to select the desired
position of the menu screen.
Select “Menu Position” in the “Options”
menu on the menu screen.
➝For operating the menu screen, see
pages 38 to 41.
On-screen Display
Center
Upper
Right
Lower
Right
Upper
Left
Lower
Left
Selected Item
The menu is displayed on the
center of the image.
The menu is displayed on the
upper right of the image.
The menu is displayed on the
lower right of the image.
The menu is displayed on the
upper left of the image.
The menu is displayed on the
lower left of the image.
Description
On-screen Display
Automatic Power Shut-
off Function
When no input signal is detected for more than
15 minutes, the projector will automatically en-
ter the standby mode if set to “
” (ON).
Select “Auto Power Off” in the “Options”
menu on the menu screen.
➝For operating the menu screen, see
pages 38 to 41.
Note
• “Auto Power Off” is factory preset to “ ”.
• When the Auto Power Off function is set to
“ (ON)”, 5 minutes before the projector
enters the standby mode, the message “En-
ter STANDBY mode in X min.” will appear on
the screen to indicate the remaining minutes.
Selected Item Description
Projector automatically enters the
standby mode after 15 minutes
without an input signal.
Automatic Power Shut-off disabled.
03.10.29, 2:46 PM Page 54