Sanyo MPX-MD162 - Manual (Page 33)

ALARM AND SENSOR SETTING Menu 4
(SENSOR SET)
When the internal video sensor detects a movement in the live
video signal, it can be set to trigger an alarm. Priority recording
of the concerned pictures can also be set (ACTIVE REC).
Setting the SENSOR SET Mode
1
Press the l button to highlight the setting to modify.
2
Using the + (or –) button, select the desired “SENSOR
ALARM” setting, then press the
l button.
Following this procedure, select the settings for “DURATION”.
3
☞ Press the MENU button to go to the next menu
screen, or
☞ Press the EXIT button to exit the menu display.
SENSOR SET menu
SENSOR ALARM (Default setting: OFF)
This will set if the internal video sensor triggers are considered
as alarm triggers.
ON: The sensor triggers will be considered as alarms, and
when received the display will switch to the selected alarm
display mode and the buzzer will be heard.
OFF: The sensor triggers are not considered as alarms.
AND: Only when a sensor trigger and an alarm trigger are
received simultaneously, it will be considered as an alarm.
NOTE: If SENSOR ALARM is set to AND, a trigger to an
ALARM IN terminal alone will not be considered as an
alarm.
DURATION (Default setting: 10 S)
When a video sensor detects a movement, this will set the active
recording mode duration (see page 33).
The available durations are:
1, 2, 3, 4, 5, 10, 20 (in 10 seconds increments)... 180
NOTE: When the SENSOR ALARM settings “ON” and “AND”
are used, the internal video sensor can trigger an alarm
operation. The alarm duration is set by the “DURATION”
setting in (ALARM SET) (see page 31).
2
(ALARM SET)
DURATION 10 S
RETRIGGER OFF
BUZZER ON
DATA ON
MON.1 OUT FULL
DOUBLE ALARM LAST
MON.2 OUT OFF
(SENSOR SET)
SENSOR ALARM OFF
DURATION 10 S
L8FC5/US (MPX-CD162, MD162 GB) 2000. 8. 31
32 English