Sony KD-32NX200U - Manual (Page 2)

NOTICE FOR CUSTOMERS IN THE UNITED KINGDOM
For KD-32NX200U models
A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience.
Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI
to BS 1362 (i.e. marked with
or ) must be used. When an alternative type of plug is used it
should be fitted with a 5 AMP fuse, otherwise the circuit should be protected by a 5 AMP fuse at
the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure
to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you
should lose the fuse cover, please contact your nearest Sony service centre.
For KD-36NX200U models
A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience.
Should the fuse in the plug supplied need to be replaced, a 13 AMP fuse approved by ASTA or BSI
to BS 1362 (i.e. marked with
or ) must be used. When an alternative type of plug is used it
should be fitted with a 13 AMP Fuse, otherwise the circuit should be protected by a 13 AMP fuse
at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be
sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover.
If you should lose the fuse cover, please contact your nearest Sony service centre.
How to replace the Fuse
Open the fuse compartment with a flat blade screwdriver, and replace the fuse.
IMPORTANT
If the plug supplied is not suitable for the socket outlet in your home, it should be cut off and an
appropriate plug fitted in accordance with the following instructions:
The wires in this mains lead are coloured in accordance with the following code:
Blue
Neutral
Brown Live
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal which is marked with the letter
N or coloured black. The wire which is coloured brown must be connected to the terminal which is
marked with the letter L or coloured red. Do not connect either wire to the earth terminal in the plug
which is marked by the letter E or by the safety earth
symbol
or coloured green or green and yellow.
WARNING
• To prevent shock hazard, do not insert the plug cut off from the mains lead into a socket outlet.
This plug cannot be used and should be destroyed.
• To prevent fire or shock hazard, do not expose the unit to rain or moisture.
• Dangerously high voltages are present inside the set. Do not open the cabinet. Refer servicing
to qualified personnel only.
ASA T
ASA T
FUSE
32nx200Ucover.fm Page 2 Monday, September 16, 2002 11:53 AM